Polycom VVX ユーザーズマニュアル

To connect another Expansion Module, attach another Cable Connector between the AUX 2 port on 
the first Expansion Module and the AUX 1 port on the second Expansion Module. You can connect a 
maximum of three Expansion Modules to one phone, as shown next.

Turn the phone and Expansion Module upside down on the table. Insert the Cable Connector 
between the AUX port on the phone, and the AUX 1 port on the Expansion Module. Thread the cable 
through the Cable Grooves on the Expansion Module and phone. If the phone is connected to the 
network, the Expansion Module will automatically power on and start up.

Position the phone and Expansion Module next to each other on a flat, level surface.  Position them 
as closely together as you can. Then, locate the holes for the thumb screws; the holes are located 
between the top-most and middle stand slot.

Connect the base stand to your Expansion Module at the same angle as your phone’s stand. 

Hold the metal bracket so that the four tabs face away from you, and the arrow on the back of the 
bracket points up. Position the holes in the metal bracket over the thumb screw holes. The four tabs 
on the bracket fit in the top-most and middle stand slots. Insert the thumb screws in the holes, and 
finger tighten.