Lucent Technologies 555-661-150 ユーザーズマニュアル
MERLIN LEGEND Communications System Release 6.1
Network Reference
Network Reference
555-661-150
Issue 1
August 1998
Network Management
Page 5-29
Uniform Dial Plan Routing
5
Special characters such as
*
, Stop, and # cannot be included as extra digits.
Pause is allowed in every position but the first.
NOTE:
Digit absorption is applied before digit prepending.
The factory setting is empty.
Valid Entries
Up to 20 digits (any combination of 0 to 9 and HOLD (P), for Pause)
Voice and/or Data Routing
5
For UDP routing, the voice/data attribute is used in conjunction with PRI tandem
trunks.
trunks.
The voice/data attribute can be associated with any UDP route.
The factory setting is Voice/Data.
Valid Entries
Voice Only, Data Only, Voice/Data
Task List: Uniform Dial-Plan Routing
5
o
Obtain Non-Local UDP Administration Form in the Installation
Specification, UDP Routing.
Specification, UDP Routing.
o
Plan changed or new non-local UDP routes using the planning guidelines
above and after consulting other system managers in the private network.
Record the new values on the form.
above and after consulting other system managers in the private network.
Record the new values on the form.
o
Ensure that tandem trunks have been assigned to pools. If necessary,
consult “Trunks to Pools Assignment” in the “Lines and Trunks” section of
System Programming.
consult “Trunks to Pools Assignment” in the “Lines and Trunks” section of
System Programming.
NOTE:
To avoid confusion and for future planning purposes, tandem trunks
and pools of tandem trunks should be numbered uniquely and
unambiguously.
and pools of tandem trunks should be numbered uniquely and
unambiguously.
o
Open the System Programming menu from the console or a PC with SPM.
o
Program the change(s), following the instructions below in the order
shown, or those for “UDP Routing” in
shown, or those for “UDP Routing” in
System Programming.
o
When you have finished, file the form with the rest of the planning forms.