Polycom SIP 3.0.2 ユーザーズマニュアル

 Configuration Files

A - 105

This configuration attribute is defined as follows:

Any field in the bootROM setup menu and the application SIP Configuration 
menu can be set through a configuration file. 
A DHCP server can be configured to point the phones to a boot server that has 
the required configuration files. The new settings will be downloaded by the 
phones and used to configure them. This removes the need for manual 

interaction with phones to configure basic settings. This is especially useful for 
initial installation of multiple phones.
These device settings are detected when the application starts. If the new 
settings would normally cause a reboot if they were changed in the application 
Network Configuration menu, then they will cause a reboot when the 
application starts.

The global device.set parameter must be enabled when the initial 

installation is done, and then it should be disabled. This prevents subsequent 
reboots by individual phones triggering a reset of parameters on the phone 
that may have been tweaked since the initial installation.

up.analogHeadsetOpti

on

0, 1

0

Selects optional external hardware for use with a headset 

attached to the phone's analog headset jack.
If set to 0, no compatible headset is attached.
If set to 1, a DHSG-compatible headset is attached and 

can be used as an electonic hookswitch.

The parameters for this feature should be put in separate configuration files to 

simplify maintenance. Do not add them to existing configuration files (such as 
sip.cfg

). One new configuration file will be required for parameters that should 

apply to all phones, and individual configuration files will be required for 

phone-specific parameters such as SIP registration information.