Patton electronic SmartNode 4110 Series ユーザーズマニュアル

NAT/NAPT configuration task list

SmartWare Software Configuration Guide 

To activate a NAT/NAPT component, bind its NAPT profile to an IP interface. This binding identifies the 
global interface of the respective NAT/NAPT component. All other IP interfaces are local relative to this NAT/
NAPT.

If both a NAPT profile and an ACL profile are bound to the same IP inter-
face, the ACL (Access Control List) acts on the local side of the NAT/
NAPT component.

Procedure: To activate a NAT/NAPT component

Mode: Configure

Example: Configuring NAPT Interface

The following example shows how to activate a NAT/NAPT component with the NAPT profile access on the 
IP interface lan.

node(cfg)#context ip router
node(ctx-ip)[router]#interface lan
node(if-ip)[lan]#use profile napt access

Two commands are available to display an existing NAPT profile. There is no command yet to display the 
dynamic entries of a NAT/NAPT component.

Procedure: To display NAT/NAPT configuration information

Mode: Configure

node(cfg)#context ip router

Selects the IP router context

node(ctx-ip)[router]#interface 
name

The NAPT profile shall be used on the interface name

node(if-ip)[name]#use profile 
napt profile

Defines that the NAPT profile profile shall be used on 
the interface name

node(cfg)#show profile napt

Displays the available NAPT profiles

node(cfg)#show profile napt 
name
or
node(cfg)#show napt interface 
name

Displays the NAPT profile name
or
Displays the NAPT profile bound to the IP interface 
name