Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Link scheduler configuration task list

SmartWare Software Configuration Guide 

Mode: Configure

Example: Defining the access control list profile

In the example below a new access control list profile named Webserver is created. In addition an IP access con-
trol list entry that permits access for host at IP address 172.16.1.20, and specifies that packets matched by this 
rule belong to the traffic-class Web is added. Finally an IP access control list entry that permits IP traffic to or 
from all IP addresses is added to the access control list.

node(cfg)#profile acl Webserver
node(pf-acl)[Webserv~]#permit ip host 172.16.1.20 any traffic-class Web
node(pf-acl)[Webserv~]#permit ip any any

After packet classification is done using access control lists, the link arbiter needs rules defining how to handle the 
different traffic-classes. For that purpose you create a service-policy profile. The service policy profile defines how 
the link arbiter has to share the available bandwidth among several traffic classes on a certain interface.

The service-policy profile defines how the link scheduler should handle different traffic-classes. The overall 
structure of the profile is as follows:

Creates a new access 
control list profile named 
name

Creates an IP access con-
trol list entry that permits 
access for host at IP 
address ip-address, and 
specifies that packets 
matched by this rule 
belong to the traffic-class 
class-name.

Creates an IP access con-
trol list entry that permits 
IP traffic to or from all IP 
addresses.