Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Configuration Summary

SmartWare Software Configuration Guide 

Next, you will need to create a WAN profile, create a WAN interface, and create a subscriber. Then, you can 
configure the DSL port (port dsl 0 0) for PPPoE. 
Follow this example:

profile napt WAN

context ip router

 interface WAN

ipaddress unnumbered

  point-to-point

  use profile napt WAN

  tcp adjust-mss rx mtu

  tcp adjust-mss tx mtu

subscriber ppp MySubscriber

  dial out

  authentication chap

  identification outbound <username> password <password>

  bind interface WAN router

port dsl 0 0

pvc vpi 8 vci 35

pppoe

session MyISP

bind subscriber MySubscriber

no shutdown

The line - 

use profile napt WAN - 

defines that the NAPT profile <profile> will be used on the ip interface 

<name>. For PPPoE, you will only use outbound for identification. You will want to use authentication, which 
is why you bind to a subscriber. You can use authentication chap or authentication pap. The line - 

bind sub-

scriber MySubscriber

 - binds the PPPoE session to the PPP subscriber, in case authentication is required. If 

you do not use authentication, then you will not have a subscriber and you will bind directly to the interface. 

The modems offer multiple bridged Ethernet connections through logical channels within the DSL link. A 
logical connection is called a Permanent Virtual Circuit (PVC) and is identified by a VPI/VCI number pair. 
Consult your provider's configuration instructions for connections used on your DSL link. You define those 
PVCs inside "port dsl 0 0": 

port dsl 0 0

  pvc vpi 8 vci 35

Iin the mode "pvc", you define what to do with the bridged Ethernet connection it offers:

•

Bind one or more IP interfaces when your providers uses fixed ip addresses or DHCP in the network

•

Enter PPPoE mode and define a PPP session if the provider is using PPPoE. 

PPPoA is not supported.