Patton electronic SmartNode 4110 Series ユーザーズマニュアル

DHCP-client configuration tasks

SmartWare Software Configuration Guide 

interface, e.g. the default gateway, DNS server IP addresses, etc. To enable the DHCP-client on an IP interface 
perform the steps described below.

Mode: context IP

If you are connected to the SmartNode by Telnet over the IP interface on 
which you enable the DHCP-client, the connection is lost after entering the 
command 

. You need to know the new IP address distrib-

uted from the DHCP-server to connect to the SmartNode again!

Example: Enable DHCP-client on an IP interface

node(cfg)#context ip
node(ctx-ip)[router]#interface eth0
node(if-ip)[eth0]#ipaddress dhcp
node(if-ip)[eth0]#show dhcp-client
------------------------------------------------------------
Context:                 router
Name:                    eth0
IpAddress:               172.16.224.102 255.255.0.0
Default gateway:         172.16.1.10
Domain Name:             pacific
DNS:                     172.16.1.10
                         146.228.10.16
Next Server Ip:          172.16.1.10
DHCP Server:             172.16.1.10
Lease obtained:          2001-01-01T01:03:51
Lease expires:           2001-01-01T09:03:51
State:                   Bound

Creates an IP interface with name name and enters 
‘configure’ configuration mode

Enables the DHCP-client on this IP interface. (See 
note)

Displays status information about the DHCP-client 
For example, default gateway, lease expire time, 
etc.