Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Introduction

SmartWare Software Configuration Guide 

This chapter describes how to configure the point-to-point protocol over different link layers.

The point-to-point protocol (PPP) provides a standard method for transporting multi-protocol datagrams over 
point-to-point links as defined by the RFC1661 etc. SmartWare offers PPP over the following link layers:

•

PPP over Ethernet (PPPoE)

•

PPP over HDLC

 shows the elements involved in the configuration of PPP. The elements required to configure PPP 

over Ethernet are located in the upper left corner of the figure. The elements for PPP over a HDLC Framed 
Serial Link are in the lower left corner. For PPP over ISDN, the elements are in the middle and the lower right 
corner.

Figure 46. PPP configuration overview

Since the purpose of PPP is providing IP connectivity over different types of link layers, all PPP configuration 
elements connect to the IP context through an IP interface. This connection is relayed via a subscriber profile if 
either PPP peer requires authentication.

For PPP over Ethernet, a PPPoE session must be configured on the respective Ethernet port. It is possible to 
set-up several (limited by the available memory) PPPoE sessions on the same Ethernet port, each session with 

Context

IP

'router'

interface

ppp / pppout

port

isdn

port

isdn

bind

subscriber

SR

bind port

<slot>

<port> *

port

serial

bind

subscriber

port

ethernet

* multiple occurrencies

PPPoE

Session
Session

interface (ip)

Subscriber

PPP

Profile

PPP

bind

interface

bind

interface

bind

interface

bind

subscriber

use

profile ppp

bind

interface

Subscriber

PPP

Subscriber

PPP

interface

pstn

Context

CS

'switch'

Profile

PPP

use

profile ppp