Patton electronic SmartNode 4110 Series ユーザーズマニュアル

PPP configuration task list

SmartWare Software Configuration Guide 

In some situations, it is useful to disconnect and reconnect a PPP session at a clearly defined time. The follow-
ing procedure shows how PPP can be configured to reconnect the connection every time a timer expires. 

A common application for this feature: some ISPs disconnect the PPP session after a fixed period of time, for 
example, 16 hours. This may cause call interruptions if it happens during the day. The timer allows to discon-
nect and reopen the PPP session at a predefined time, such as 0200 hours.

Mode: subscriber ppp <subscriber>

This procedure enables/disables automatic configuration of the interface IP address from the PPP network 
control protocol negotiation.

Mode: profile ppp

PPP can run over Ethernet (PPPoE). The active discovery protocol identifies the PPP remote peer on the Ether-
net and establishes a PPPoE session with it. The PPPoE session provides a logical point-to-point link that to 
runs PPP as if it was a physical point-to-point link (e.g. a serial link).

This procedure describes how to configure an Ethernet port and a session for PPPoE

[name] (subscr)[subscriber]# [no] timeout on-
timer <timer>

Enables/disables forced reconnect every time 
the timer <timer> expiries.

Enables/disables autoconfiguration of the local 
IP address from PPP. Default: enabled.