Patton electronic SmartNode 4110 Series ユーザーズマニュアル

PPP Dial-up over ISDN

SmartWare Software Configuration Guide 

Debug dialer functionality
The following commands show how to display information and events of a PPP dialer.

Mode: enable

Mode: enable

Example – Dial-on demand feature
The following example shows a configuration snippet to configure a backup-interface that uses the dial-on 
demand feature to establish a backup-connection to the remote network. The remote network can be reached 
either over the dial-in infrastructure of provider 1 or provider 2. Both need different credentials.

context ip

  interface IF_PRIMARY
    ipaddress 10.1.1.2 255.255.255.0
    check-connectivity ping 10.1.1.1

  interface IF_SECONDARY
    ipaddress unnumbered
    point-to-point
    dial-up monitor interface IF_PRIMARY

  route 0.0.0.0 0.0.0.0 10.1.1.1 0
  route 0.0.0.0 0.0.0.0 IF_SECONDARY 1

subscriber ppp SUB_PROVIDER1
  dial out
  authentication chap pap
  identification outbound MY_NAME password MY_PASSWORD
  bind interface IF_SECONDARY

subscriber ppp SUB_PROVIDER2
  dial out
  authentication pap
  identification outbound USER password PWD
  bind interface IF_SECONDARY

context cs

Shows configuration and state information 
about a certain dialer instance.

Enables logging of dialer events and state 
changes.

Enables logging of PPP protocol events. See 

 on page 325 for further 

information.