Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Introduction

SmartWare Software Configuration Guide 

This chapter provides an overview of interfaces in the CS context and describes the tasks involved in their con-
figuration. Within the CS context, an interface is a logical entity providing call signaling for incoming and out-
going calls to and from telephony ports and voice over IP gateways. It represents logical connections to other 
equipment or networks. CS interfaces are used as source and destination in the call router and are bound to 
physical ports or logical gateways.

Interface names can be any arbitrary string with a maximum of 25 characters. For ease of identification, the 
interface type can be a part of the name. 

 illustrates the function of the CS interfaces. The types of CS 

interfaces are:

•

PSTN interfaces telephony. Binding is done from a port to an interface.

•

VoIP interface provide voice over IP settings in addition to the general CS interface parameters. These inter-
faces must be explicitly bound to an existing VoIP gateway.

Figure 52. CS interfaces on the CS context

Interfaces can use mapping tables and precall service tables to manipulate call properties before the call is being 
offered to the call router.

Several parameters depend upon the interface type. If it is not specifically stated otherwise, the configuration 
task is valid for all interfaces. This is not described in this chapter, but in chapter

Context CS

switch

H.323 GW

SIP GW

bind command

FXS interface

H.323 interface

SIP interface

ISDN Port

FXS Port

ISDN interface

mappping

table

use command