Patton electronic SmartNode 4110 Series ユーザーズマニュアル

ISDN interface configuration task list

SmartWare Software Configuration Guide 

Normally, the call-hold feature is disabled on ISDN point-to-point links and enabled on ISDN point-to-mul-
tipoint links. However, you can manually enable or disable the Call-Hold feature using the following com-
mand: The default setting can be achieved using the ‘auto’ configuration option.

Mode: interface isdn

By default no display information elements are sent in ISDN signaling messages. You can enable sending of 
ISDN Display Information elements in ISDN signaling messages using the following command.

Mode: interface isdn

ISDN allows to propagate current time and date information from a port configured as network to the con-
nected terminals. You can configure each ISDN interface to propagate the current SmartNode system time and 
date to the connected terminals with the following command:

Procedure: To configure date and time publishing

Mode: Interface ISDN

Date and time information can only be contained in the ISDN CONNECT message. This message is only 
delivered to a terminal when a call from the terminal to the SmartNode is made, and reaches connected state.

Enable or disable the call-hold functionality for 
an isdn interface. If ‘auto’ is selected, call-hold is 
automatically disabled on p2p links and enabled 
on p2mp links.
Default: auto

Enable sending of the display information ele-
ment for an isdn interface.
Default: disabled

node(if-isdn)[if-name]#[no] isdn-date-time Enable/disable publishing of system time to con-

nected ISDN terminals (default: disabled)