Patton electronic SmartNode 4110 Series ユーザーズマニュアル

FXS interface configuration task list

SmartWare Software Configuration Guide 

Frequency-shift keying
Frequency-shift keying signaling can be specified in FXS port configuration mode, in one of the following for-
mats:

1. Multiple Data Message Format (MDMF) (etsi standard) (default).

2. Single Data Message Format (SDMF) (bell standard).

To enable frequency-shift keying by MDMF standard, use the existing caller-id format command.

MDMF(etsi) is a default value and it will not be visible in “show running-
config” output.

To enable frequency-shift keying by SDMF standard, use existing caller-id format command (please note that 
as of May 21st, 2008 there were no confirmed test results about SDMF frequency-shift keying signaling func-
tioning properly):

The tone cadence for stutter dial tone can be set in profile tone-set mode. 
The tone type name for a tone that should represent a waiting message is 
message-waiting-tone and by default it is set to defaultStuttertone 
(on,100,425,-7,off,100). Refer to Chapter 42,

page 529 for information on setting up tone profiles.

Selects MDMF standard for sending frequency-shift 
keyed messages

Selects SDMF standard for sending frequency-shift 
keyed messages