Patton electronic SmartNode 4110 Series ユーザーズマニュアル

FXO services description

SmartWare Software Configuration Guide 

The wide variety of applications and services are supported through a rich feature set. The major characteristics 
and features are

•

2-wire loop-start

•

Off-hook and ring detection supervision

•

Automatic and programmable line gain

•

Programmable ring count before call pick-up

•

End-of-call detection by line drop (call release indication), busy tone detection and battery reversal detection

•

Hook-flash sending: programmable duration, H.245 hook-flash relay (“!” in user input) which provides 
Cisco compatibility

•

DTMF send and detect: programmable interdigit timer, DTMF-relay

•

Caller ID (CLID) and Caller ID names FSK command line interface reception and relay to VoIP signaling 
(Bellcore/ANSI and ETSI/ITU)

•

Call routing based on caller ID

•

Second dial-tone for two-stage DTMF dialing with call routing based on DTMF numbers.

Interface names can be any arbitrary string. Use self-explanatory names for your interfaces to reflect their 
usage in your application. After creating the FXO interface, it is necessary to bind the FXO interface. Refer 
to chapter 44,

Mode: Context CS

You enter Context CS, one of the configuration modes, as follows.

Node is the host name you have assigned to your SmartNode and is the 
basic prompt.

Basic prompt in Operator Exec mode

Enters Administration execution mode

The prompt in administration execution mode

Enters the Configure configuration mode

The prompt in the Configure configuration mode

Enters the context “CS” for Circuit Switch

The prompt in the Context CS configuration mode