Patton electronic SmartNode 4110 Series ユーザーズマニュアル

ページ / 664
Introduction
432
SmartWare Software Configuration Guide 
38 • H.323 interface configuration
Introduction
This chapter provides an overview of H.323 interfaces used by H.323 gateways and describes the specific tasks 
involved in their configuration. This chapter does not explain the basic configuration steps required for all CS 
interfaces. Information about basic interface configuration can be found in the general chapter about CS inter-
face configuration.
Within the CS context of SmartWare, an H.323 interface is a special type of CS interface providing call rout-
ing for incoming and outgoing calls to and from the H.323 gateway (see 
Figure 59. H.323 interfaces on the CS context
An H.323 interface is a CS interface type that also provides voice over IP settings in addition to the general CS 
interface parameters. All H.323 interfaces must be explicitly bound to an H.323 gateway. Calls, which are 
routed from the Context CS to one of the H.323 interfaces, will be forwarded for call establishment to the 
H.323 gateway to which the H.323 interface is bound. All the parameters configured in the H.323 interface 
will be applied to the forwarded call.
When a call arrives over H.323 in the H.323 gateway. The gateway looks for the best matching H.323 inter-
face, which is bound to that gateway. If there is an H.323 interface, which contains the IP address of the source 
of the H.323 call in its remoteip configuration parameter, the call will be handed over to that interface for fur-
ther call processing. If no such interface is found, the gateway looks for an interface, which is bound to that 
gateway and does not contain a remoteip parameter. If such an interface is found the call will be handed over to 
that interface for further processing. If however such an interface is also not available, the call will be dropped.
H.323 
interface configuration task lis
t
This section describes the configuration tasks for H.323 interfaces listed below. You must at least perform the 
tasks, which are not marked as optional, to define a working H.323 interface. The optional tasks are usually 
only required in advanced configurations. Before you can start with the H.323 interface specific configuration 
tasks, you need to create the H323 interface and define the routing for it as defined in chapter 33,
Binding the interface to an H.323 gateway
Configuring a remote IP address
Using an alternate VoIP profile (optional)
bind commands
H.323 Interface
Context CS
H.323
Gateway