Patton electronic SmartNode 4110 Series ユーザーズマニュアル

H.323 interface configuration task list

SmartWare Software Configuration Guide 

Mode: Interface H.323

Example: Enable CLIP/CLIR support

The following example shows how to enable CLIP/CLIR support on the H.323 interface MyH323If.

node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface h323 MyH323If
node(if-h323)[MyH323If]#clip-clir-support

The 

 command can enable the early-proceeding feature on H.323. If this feature is enabled, 

the gateway will immediately reply with an H.225 (H.323) call-proceeding message in response to a received 
H.225 (H.323) setup message without waiting for a response from the destination. 

Mode: interface h323 <if-h323>

Example: Enable early call disconnect

The following example shows how to enable early call disconnect on an H.323 interface named MyH323If.

node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface h323 MyH323If
node(if-h323)[MyH323If]#early-disconnect

The 

 command can be enabled to open a data path before the call is connected to play inband 

information from the ISDN side. 

Mode: interface h323 

node(if- h323)[if-name]#clip-clir-support Enables CLIP/CLIR support on the H.323 

interface

[name](if-h323)[if-name]#early-proceeding Enables the early-proceeding feature.

Enables the early-connect feature.