Patton electronic SmartNode 4110 Series ユーザーズマニュアル

SIP interface configuration task list

SmartWare Software Configuration Guide 

Mapping SIP headers to call-control properties
This functionality specifies rules that describe which SIP header should take place as a specific call-control 
property like the called-e164 or the calling-e164 number.

Mode: Interface SIP

Configuring ISDN Redirecting Number Tunneling Over SIP
A SIP interface can be configured to tunnel the ISDN Redirecting E.164 Number and Redirecting Reason. 
This is implemented per the IETF draft standard method according to draft-jennings-sip-voicemail-uri-05.

The figure below shows a call that is redirected in the PSTN network and reaches the device over an ISDN 
interface. The incoming ISDN SETUP message contains additional information elements for the Redirecting 
Party Number (B) and the Redirecting Reason (Call-Forwarding-Unconditional, for example). When the 
Redirecting Number Tunneling over SIP has been enabled, the Request-URI of the outgoing SIP INVITE 
message has additional parameters for the redirected number (target) and the redirecting reason (cause).

Normally, the Redirecting Number Tunneling over SIP is disabled. However, you can manually enable this fea-
ture for each SIP interface separately using the following commands. Note that transmission and reception of 
the target and cause parameters must be configured separately.

Specifies an incoming address translation 
rule.