Patton electronic SmartNode 4110 Series ユーザーズマニュアル
SIP interface configuration task list
455
SmartWare Software Configuration Guide
39 • SIP interface configuration
Configure the SIP hold method (Optional)
There are different ways to set a remote SIP subscriber On Hold. This command specifies which method the
SmartNode uses to indicate this call state. In receive direction, all of them will be accepted.
SmartNode uses to indicate this call state. In receive direction, all of them will be accepted.
Mode: Interface SIP
Step
Command
Purpose
1
[node](if-sip)[if-name]#hold-method
{direction-attribute | zero-ip}
{direction-attribute | zero-ip}
Configures the method to be used to signal
the hold state.
Default: zero-ip
the hold state.
Default: zero-ip