Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Call router configuration task list

SmartWare Software Configuration Guide 

When you specified a national or international prefix using the commands 
national-prefix or international-prefix respectively. in the context CS config-
uration mode, the calling or called party number is extended with the speci-
fied prefix and the type-of-number is set to unknown in the incoming 
interface. Thus an international number can enter the call-router as 
unknown number.

This property is only set by incoming ISDN calls. A call that arrives the call 
router from a FXS or SIP interface has a number type of Unknown as those 
interfaces do not support the number type property.

The call router can route calls according to the following number types. These values beside default can be used 
for the key parameter to create a routing table entry:

•

unknown—Unknown number type. This is the default value for calls that arrive through an interface that 
does not support the number type property.

•

international—International number; the number does not include prefix or escape digits.

•

national—National number; the number does not include prefix or escape digits.

•

network-specific—Network specific number, used to indicate administration or service number specific to 
the serving network, e.g. used to access an operator.

•

subscriber—Subscriber number; the number does not include prefix or escape digits.

•

abbreviated—Abbreviated number.

Example: Calling type-of-number routing table

The following example routes calls with an international calling party number to the next table TAB-INCOM-
ING-INT, calls with a national calling party number to the next table TAB-INCOMING-NAT and all other 
calls to the next table TAB-INCOMING-UNKNOWN.

node(cfg)#context cs
node(ctx-cs)[switch]#routing-table calling-type-of-number TON
node(rt-tab)[TON]#route international dest-table TAB-INCOMING-INT
node(rt-tab)[TON]#route national dest-table TAB-INCOMING-NAT
node(rt-tab)[TON]#route default dest-table TAB-INCOMING-UNKNOWN

The calling party numbering plan or called party numbering plan (calling-number-plan or called-numbering-
plan) table is used to route calls based on the calling or called party numbering plan field in the ISDN setup 
message. This can be used to differentiate calls between numbers of an ISDN, data, telex, national standard or 
private numbering plan.

This call property is only set by incoming ISDN calls. A call that arrives the 
call router from a FXS or SIP interface has a numbering plan of unknown.