Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Call router configuration task list

SmartWare Software Configuration Guide 

Incoming ISDN calls set the presentation indicator according to the received 
ISDN Setup message. Incoming H.323 calls only set the presentation indi-
cator transparently when Octet3a handling is enabled. Other interfaces set 
the presentation indicator to allowed. 

The call router can route calls according to the following presentation indicators. These values beside default 
can be used for the key parameter to create a routing table entry:

•

allowed—Presentation of the calling party number is allowed. This is the default value for calls that arrive 
through an interface that does not support presentation indicators.

•

restricted—Presentation of the calling party number is restricted.

•

interworking—The calling party number is not available due to interworking.

At the originating user-network interface, the presentation indicator is used 
for indicating the intention of the calling user for the presentation of the 
calling party number to the called user. You possibly want to remove the call-
ing party number when the user set the presentation indicator to restricted. 
To achieve this, route restricted calls to a mapping table that sets the calling-
e164 to the empty string (“”) as it is shown in the example below.

Example: Presentation indicator routing table

This example uses a pseudo routing table that just forwards all calls to the interface IF-OUT but first executes 
the mapping table NO-CNPN. This mapping table examines the presentation indicator and modifies the call-
ing party number. If the presentation indicator is restricted, the calling party number is cleared. For all other 
presentation indicator values, the calling party number is not modified.

node(cfg)#context cs
node(ctx-cs)[switch]#routing-table calling-pi PI
node(rt-tab)[PI]#route default dest-interface IF-OUT NO-CNPN
node(rt-tab)[PI]#exit
node(rt-tab)[switch]#mapping-table calling-pi to calling-e164 NO-CNPN
node(map-tab)[NO-CNPN]#map restricted to “”

The screening indicator (calling-si) table is used to route calls based on the screening indicator of the calling 
party number. A network validates the calling party’s number and puts the validation result to the screening 
indicator. This allows a network to transparently pass the calling party number set by the calling user, but tell 
the called user whether or not the number selected by the calling party really belongs to him or her.

Incoming ISDN calls set the screening indicator according to the received 
ISDN Setup message. Incoming H.323 calls only set the screening indicator 
transparently when Octet3a handling is enabled. Other interfaces set the 
screening indicator to user-not-screened.