Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Call router configuration task list

SmartWare Software Configuration Guide 

To remove the first two entries from the complex function enter the following commands. Pay attention on the 
index. When removing the first entry, the MAP2 function becomes entry with index 1. Thus you have to spec-
ify index 1 twice to remove the first two entries:

node(cfg)#context cs
node(ctx-cs)[switch]#complext-function MY-FUNC
node(func)[MY-FUNC]#no execute 1
node(func)[MY-FUNC]#no execute 1

The resulting running-config is:

complex function MY-FUNC
  execute 1 MAP3
  execute 2 MAP4

Procedure: To delete an entire complex function

Mode: Context CS

Example: Remove an entire complex function

node(cfg)#context cs
node(ctx-cs)[switch]#no complex-function MY-FUNC

Sending-Complete
The call-router can be configured how to handle address-complete indications (e.g. ISDN Sending-Complete 
IE). On ISDN, H.323 and SIP interfaces, an address-complete-indication command controls the tunneling of 
address-complete indications separately for incoming and outgoing calls.

Each interface can be configured to pass transparently address-complete indications, or to explicitly insert or 
remove it for incoming and outgoing calls. In addition the behavior of the call-router can be configured.

Some call signaling protocols allow a user to dial a destination by using the overlap-sending procedure. These 
protocols include analog telephony (FXS/FXO), ISDN and H.323. ISDN and H.323 support address-com-
plete indication using the Sending-Complete Information Element. Other protocols wait on a timeout or send 
a terminating character, e.g. pound (#), to indicate address-completion.  The following commands control the 
tunneling of address-complete indications from the signaling protocol to the internal call-control representa-
tion and vice-versa. In addition, the context cs introduces command extensions that control the address-com-
pletion handling in the internal call-router.

Ingress interface
On the ingress interface (ISDN, H.323 or SIP) the address-complete-indication accept <type> command 
configures how to map the address-complete indication of the signaling-protocol to the internal call-control. 
There the indication can be used for call-routing (see below) or mapped again to an address-complete indica-
tion on an egress interface (see below). 

node(ctx-cs)[switch]#no complex-
function

Delete the complex function function-name.