Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Call router configuration task list

SmartWare Software Configuration Guide 

Mode: Context CS

context cs switch

  routing-table called-e164 DISPATCH
    route 1 dest-service BRIDGE1.dialer
    …

  service bridge BRIDGE1
    port listener
      mode listening
      no shutdown
    port dialer
      mode dial-persistent 1 dest-interface REMOTE
      no shutdown 
 
interface h323 REMOTE
    bind gateway h323
    route call dest-table DISPATCH
    remote 172.16.32.37

  interface fxs PHONE1
    route call dest-service BRIDGE1.listener

If a call is routed into the service second-dialtone, the service establishes the call and plays a dial tone to the 
caller.When a call is entering the service it is first routed to the configured destination. In case the call cannot 
be placed, the service plays the second dial-tone or the configured announcement to the caller until the caller 
enters the first DTMF digit.

Enters the bridge service configuration mode / deletes a 
bridge service.

Creates a port on the service that can accept or spawn calls 
(the max number of ports is currently limited to two)

Configures the port to actively dial the called-party “123” to 
the destination REMOTE. This connection is kept open until 
the service is shut down, or a “no dial” command is issued. If 
the remote side terminates the connection, the port tries to 
reconnect. As soon as the connection is established, the call 
is connected to all other calls present on the service.

Creates a port on the service that can accept or spawn calls 
(the max number of ports is currently limited to two)

Without entering a “dial” command, or by specifying “no 
dial”, this port does not dial, but listen for incoming calls. If a 
call comes in, it is automatically connected to all other calls 
present on the service.