Patton electronic SmartNode 4110 Series ユーザーズマニュアル
Call router configuration task list
522
SmartWare Software Configuration Guide
40 • Call router configuration
Call reroute
The call-reroute commands enable acceptation and emission of rerouting requests.
The call-reroute commands enable acceptation and emission of rerouting requests.
Enable acceptation of rerouting requests on ISDN. If a reroute is accepted, the participant who sends the
reroute request is disconnected and the call is established from the SmartNode to the new destination.
reroute request is disconnected and the call is established from the SmartNode to the new destination.
Mode: context cs/interface isdn
Enable emission of rerouting requests on ISDN. To reroute a call must enter and leave SmartNode through
the same ISDN interface and every service invoked must allow push-back.
the same ISDN interface and every service invoked must allow push-back.
Mode: context cs/interface isdn
Enable sending of “302 moved temporary” message on SIP. To reroute a call must enter and leave Smart-
Node through the same SIP gateway and every service invoked must allow push-back.
Node through the same SIP gateway and every service invoked must allow push-back.
Mode: context cs/interface sip
Allow Push-Back
The push-back command allows or forbids rerouting of a call, if the service is invoked.
The push-back command allows or forbids rerouting of a call, if the service is invoked.
Enable push-back – aaa service.
Mode: context cs/service aaa
Step
Command
Purpose
1
[name](if-isdn)[interface]#[no] call-
reroute accept
reroute accept
Enables acceptation of rerouting requests from ISDN.
Default is disabled.
Default is disabled.
Step
Command
Purpose
1
[name](if-isdn)[interface]#[no] call-
reroute emit
reroute emit
Enables emission of rerouting requests from ISDN.
Default is disabled.
Default is disabled.
Step
Command
Purpose
1
[name](if-sip)[interface]#[no] call-
reroute emit
reroute emit
Enables emission of “302 moved temporarily” message on
SIP. Default is disabled.
SIP. Default is disabled.
Step
Command
Purpose
1
[name](svc-aaa)[service]#[no]
allows-push-back
allows-push-back
Enables push-back of a call of this service.
Default is disabled.
Default is disabled.