Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Accessing the SmartWare CLI task list

SmartWare Software Configuration Guide 

•

Ending a Telnet or console port session (see 

If a console port is available, the host computer can be connected directly to it with a serial cable (see 

The host must use a terminal emulation application that supports serial interface communication.

Figure 6. Setup for initial configuration via the console port

You do not need to configure IP settings if you access the SmartNode via the 
console port.

Console port procedure
Before using the CLI to enter configuration commands, do the following:

1. Set up the hardware as described in the getting started guide.

2. Configure your serial terminal as described in the getting started guide.

3. Connect the serial terminal to your SmartNode. Use a serial cable according to the description in the get-

ting started guide included with your SmartNode device.

4. Power on your SmartNode. A series of boot messages are displayed on the terminal screen. At the end of 

the boot sequence, press the <return> key and the login screen will be displayed.

5. Proceed with logging in.

Node

Node

Console

Host

Serial interface