Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Gateway configuration task list

SmartWare Software Configuration Guide 

For example to disable signature verification of RCF messages enter the command 

. When not specifying the message type, you change the behavior of all message types. Addi-

tionally there are special message-types that manipulate the behavior of message-groups: 

'request' ==> ARQ, BRQ, DRQ, GRQ, IRQ, LRQ, RAI, RRQ, SCI, URQ 
'response' ==> ACF, BCF, DCF, GCF, IACK, IRR, LCF, RAC, RCF, RIP, SCR, UCF 
'reject' ==> ARJ, BRJ, DRJ, GRJ, INAK, LRJ, RRJ, URJ 
E.g. 'no h235-security ras-auth-int-rx reject' disables verification of the H.235 
signature of all received reject messages, e.g. GRJ, RRJ, ARJ.

The default setting is: 

h235-security ras-auth-int-rx request 
h235-security ras-auth-int-rx response 
no h235-security ras-auth-int-rx reject 
h235-security ras-auth-int-tx request 
h235-security ras-auth-int-tx response 
no h235-security ras-auth-int-tx reject 

The command 

 shows the current setting.

node(gw-h323)[h323]#h235-security ras-
auth-int-tx [<msg>]

node(gw-h323)[h323]#no h235-security 
ras-auth-int-tx [<msg>]

Enables or disables H.235 security for trans-
mitted RAS packets. msg is the message type.

node(gw-h323)[h323]#h235-security q931-
auth-int

node(gw-h323)[h323]#no h235-security 
q931-auth-int

Enables or disables H.235 security for call-
signaling.

node(gw-h323)[h323]#h235security

If all parameters are set, enables H.235 secu-
rity. Otherwise returns an error message.

node(gw-h323)[h323]#show h235security

Shows status of H.235 security module.

node(gw-h323)[h323]#debug h235security 
[detail 

Enables the H.235 debug monitor to display 
information for every received and sent H.323 
signaling message.