Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Gateway configuration task list

SmartWare Software Configuration Guide 

You can display basic status information of the H.323 gateway using the following command:

Mode: Configure

Example: Display H.323 gateway status information

The following example shows how to display H.323 gateway status information and a sample output of the 
command.

node(cfg)#show gateway h323 status
            H.323 Gateway:                          h323
            State:                                 UP
            Stack Handle:                          0xb6a70c
            RAS Engine
            State:                               UNREGISTERED
            Allocated Endpoints:                   0
            Allocated RAS Engines:                 1
            Allocated Control Channels:            0
            Allocated Outgoing Logical Slowstart Channels: 0
            Allocated Outgoing Logical Faststart Channels:0
            Allocated Incoming Logical Channels:0

The H.323 gateway also provides several debugging monitors to observe its dynamic behavior. These monitors 
allow efficient troubleshooting of H.323 problems. The most often used monitors are listed in the following 
table. 

node(gw-h323)[h323]# show gateway 
h323 status  [detail level]

Displays H.323 gateway status information. 
The detail level parameter is a number in the 
range 0 to 5 and indicates how much detail 
should be displayed.

Logs all errors detected within the H.323 gateway

Logs all H.225 call signaling messages sent or received 
over the IP network.

Logs all H.225 RAS messages sent or received over 
the IP network

Logs information related to media channels

Logs call signaling related information