Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Examples

SmartWare Software Configuration Guide 

Different applications require different VoIP profiles. This section includes a variety of applications and show 
how the VoIP profile for these applications would be configured.

 is an example of a home office in an enterprise network. The connection bandwidth is 128 kbps and 

is of very low quality, so the low bit-rate G.723_6k3 codec is used. Likewise, silence suppression is enabled. 
Because of the low bit-rate codec, DTMF relay is also enabled. As 80 to 100 ms jitter is anticipated, the dejitter 
buffer is set to adaptive with a maximum delay of 100 ms. 

Figure 7. Home office in an enterprise network

First, configure the required CS interfaces (see chapter 33,

routing (see chapter 40,

Next, configure the voice over IP settings as needed based on the previous description. First we create the VoIP 
profile with the needed configurations.

1 node>enable
2 node#configure
3 node(cfg)#profile voip Wire128kbit
4 node(pf-voip)[Wire128~]#no codec g711aLaw64k
5 node(pf-voip)[Wire128~]#no codec g711uLaw64k
6 node(pf-voip)[Wire128~]#codec g723-6k3 tx-length 30 rx-length 30 silence-suppres-
sion
7 node(pf-voip)[Wire128~]#dejitter-max-delay 100
8 node(pf-voip)[Wire128~]]#show profile voip Wire128kbit
VoIP Profile: Wire128kbit
=========================

 Used:                                  by 0 module(s)

 Codecs
 ------

Node

Node

Node

Node

IP

Network

PSTN

PBX

LAN

PC

ISDN Phone

128 kbit/s Codec G.723_5k3