Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Examples

SmartWare Software Configuration Guide 

  Error Correction:                     enabled
  HDLC:                                 enabled
  Dejitter Max Delay:                   200ms

 Modem
 -----

  Max. Bit Rate:                        14400
  Volume:                               -9.500dB
  HDLC:                                 enabled

 DTMF
 ----

  Relay:                                enabled
  Mute Encoder:                         enabled

 RTP
 ---

  Payload Type NTE:                     101

3. Create VoIP profile and give it a name. All settings have default values

4., 5. Remove the default codecs G.711alaw and G.711uLaw

6. Add codec g729 with silence-suppression enabled

7. Allow the dejitter buffer to compensate 100 milliseconds of network jitter.

8. Enable fax relay over T.38 protocol

9. Limit the maximum bit rate the fax devices can communicate with each other to 9600 kbps

10. Show the configured profile.

A soft phone client can only use G.711uLaw or G.723 codes, neither of which can use silence suppression, 
DTMF relay, or fax.

1 node>enable
2 node#configure
3 node(cfg)#profile voip softPhone
4 node(pf-voip)[softPho~]#no codec g711aLaw64k
5 node(pf-voip)[softPho~]#codec g723-6k3 tx-length 30 rx-length 30 no-silence-sup-
pression
6 node(pf-voip)[softPho~]#no dtmf-relay
7 node(pf-voip)[softPho]]#show profile voip softPhone
VoIP Profile: softPhone
=======================

 Used:                                  by 0 module(s)

 Codecs
 ------