Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Filtering debug monitor output

SmartWare Software Configuration Guide 

The output of the debug monitors can be filtered using the following command to let the terminal only print 
important information. The specified expression is a regular expression, which is used by the filter to select 
important lines. 

Mode: Configure

The following example activates a filter, which causes the debug monitors to print only lines containing the 
word ERROR on the terminal:

terminal monitor-filter .*ERROR

Only one filter expression can be active at a time. If you enter the command 
a second time, the new filter expression will replace the old one. 

The following command will disable the filter completely: 

no terminal monitor-filter

This procedure describes how to use the 

 command to test IP connectivity. It verifies that your SmartNode 

can communicate with such hosts as a gatekeeper, and IP phone, a registrar, and other VoIP gateways.

Use Telnet to access your SmartNode, then use the 

 command to verify that an IP packet can be sent to, 

and received from, all hosts with which the SmartNode should be able to communicate (e.g. Gatekeeper, IP 
phone, Registrar, other VoIP gateways).

Mode: Administrator execution

Example: Verify IP connectivity

The following example uses the 

 command to test connections to remote hosts 192.195.23.10 and 

172.16.40.122. The results show an unsuccessful attempt to contact host 192.195.23.10 (as indicated by the “No 

Enables the monitor filter using the 
specified expression.

Determines whether an IP host can be contacted.