Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Accessing the SmartWare CLI task list

SmartWare Software Configuration Guide 

Use the 

 command in the operator or administration execution mode to end a Telnet or console port ses-

sion. To confirm the 

 command, you must enter yes on the dialog line as shown in the example below.

Mode: Operator execution

Example: End a Telnet or console port session

The following example shows how to terminate a session from the administrator execution configuration 
mode.

node>logout
Press 'yes' to logout, 'no' to cancel :

After confirming the dialog with “yes”, the Telnet session is terminated.

Using the command 

 in the operator execution mode also terminates a 

Telnet or console port session, but without any confirmation dialog.

If a command is set to its default value, it is not displayed in the running-config in order to make it more read-
able. There are a few exceptions to this rule. The command cli config defaults makes commands also appearin 
the running-config that are set to default values. no li config defaults turns it off.

Terminates the session after a confirmation by the user.