Patton electronic SmartNode 4110 Series ユーザーズマニュアル

Basic system management configuration task list

SmartWare Software Configuration Guide 

System resets may have a number of reasons, the most prominent being a manual reset issued on the Telnet/
console (‘reload’). Other reset reasons include power off failures and system failures. In order to pinpoint the 
problem, the reset log contains the reset cause.

Mode: Administrator execution

The show reports command is used to dump combined system information. The show reports command 
sequentially executes the following log commands:

show version
show clock
show uptime
show licenses
show memory stat
show log reset
show log boot
show log event
show log supervisor
show factory-config
show startup-config
show running-config

Mode: Administrator execution

The SmartWare command shell includes a basic set of commands that allow you to control the execution of 
other running commands. In SmartWare, the commands 

 and 

 are used for such purposes. The com-

mand 

 lists all running commands, and 

 allows switching back a suspended command to the fore-

ground. Moreover using <ctrl>-<z> suspends an active command and lets the system prompt reappear. With 
<ctrl>-<c> the currently active command can be terminated.

Show event log.

node#show log supervisor Show log of the system supervisor. Used For example, after an unex-

pectedly reboot.

Output a list of reset reasons (with date and time).

Displays the console and log messages captured during startup of the 
unit.

Displays a list of succeeded and failed CLI login attempts.

Displays the history of all recently executed file transfer operations 
(up to 50 entries).

Dumps the combined system information.