ZyXEL Communications FMG3025-D10A ユーザーズマニュアル
Chapter 5 Broadband
FMG3024-D10A / FMG3025-D10A Series User’s Guide
71
Figure 14
Network Setting > Broadband
The following table describes the fields in this screen.
5.2.1 Add/Edit Internet Connection
Use this screen to configure a WAN connection. The screen varies depending on the interface type,
encapsulation, and WAN service type you select.
encapsulation, and WAN service type you select.
5.2.1.1 Routing- PPPoE
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon
next to the connection you want to configure. Select Routing as the encapsulation mode, and
PPPoE as the WAN service type.
next to the connection you want to configure. Select Routing as the encapsulation mode, and
PPPoE as the WAN service type.
Table 5
Network Setting > Broadband
LABEL
DESCRIPTION
Switch WAN Mode
Add new WAN
Interface
Interface
Click this to create a new WAN interface.
#
This is the index number of the connection.
Name
This is the service name of the connection.
Mode
This shows whether the connection is in routing mode or bridge mode.
Encapsulation
This shows the method of encapsulation used by this connection.
IPv6/IPv4 Mode
This shows the IPv6/IPv4 mode: IPv4 Only, IPv6/IPv4 DualStack - IPv4
and IPv6 at the same time, or IPv6 Only.
and IPv6 at the same time, or IPv6 Only.
Vlan8021p
This indicates the 802.1P priority level assigned to traffic sent through this
connection. This displays N/A when there is no priority level assigned.
connection. This displays N/A when there is no priority level assigned.
VlanMuxId
This indicates the VLAN ID number assigned to traffic sent through this
connection. This displays N/A when there is no VLAN ID number assigned.
connection. This displays N/A when there is no VLAN ID number assigned.
IGMP Proxy
This shows whether IGMP (Internet Group Multicast Protocol) is activated or
not for this connection. IGMP is not available when the connection uses the
bridging service.
not for this connection. IGMP is not available when the connection uses the
bridging service.
NAT
This shows whether NAT is activated or not for this connection. NAT is not
available when the connection uses the bridging service.
available when the connection uses the bridging service.
Default Gateway
This shows whether the Device uses the interface of this connection as the
system default gateway.
system default gateway.
Modify
Click the Edit icon to configure the connection.
Click the Delete icon to delete this connection from the Device. A window
displays asking you to confirm that you want to delete the connection.
displays asking you to confirm that you want to delete the connection.