Avaya VF 3000 ユーザーズマニュアル

Step 4. From Checkpoint Smart Dashboard application, Select Network Objects Æ Group Æ 
HIPT-B1_eth4. Add the static 1-to-1 NAT called “HT_B1_LSP_StaticNat” from the Not in 
Group table to the In Group table and click OK as shown in Figure 50.  To activate changes 
made to HIPT-B1, select Policy Æ Install from the Checkpoint SmartDashboard menu. Select 
HIPT-B1 Æ OK for policy changes to be activated. 
 

 

The following are steps that can be used to verify the configuration described in these 
Application notes are correct. 

•  Verify the Media Gateway in the enterprise site is registered with Avaya Communication 

Manager by running the “list media gateway” command from the SAT interface. The 
Media Gateway form will show a “y” to the right of the screen for each Media Gateway 
that is registered. 

•  Verify LSP IP connectivity from the enterprise site to Avaya Communication Manager. 

To verify, run command “ping” from Avaya Communication Manager and Local 
Survivable Processor (LSP) enterprise site. The results should have no packet loss. 

•  Verify the LSP in the enterprise site is registered with Avaya Communication Manager 

by running the “disp lsp”command from the SAT interface. The lsp form will show 
Service State (In Service) for each LSP registered to Avaya Communication Manager. 

 

TC; Reviewed: 
PV 04/24/2006 

Avaya – Proprietary 

Use as authorized only pursuant to your signed agreement or 

Avaya policy. No other disclosure is permitted or authorized. 

59 of 61 

HT3-LSP-VF.doc