Panasonic KXTG9382T ユーザーズマニュアル
Useful Information
52
For assistance, please visit http://www.panasonic.com/help
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message
Cause/solution
Busy
L
The called unit is in use.
L
Other units are in use and the system is busy. Try again later.
L
Privacy mode is on for the call you tried to join (page 21).
L
The handset you are using is too far from the base unit. Move
closer and try again.
closer and try again.
L
The handset’s registration may have been canceled. Re-
register the handset (page 33).
register the handset (page 33).
Check tel line 1
Check tel line 2
L
The supplied telephone line cord has not been connected yet or
not connected properly. Check the connections (page 10).
not connected properly. Check the connections (page 10).
L
If you use the unit as a single-line telephone only, erase the
message as follows:
message as follows:
To erase “Check tel line 1”, press {MENU}. i
{#}{
{#}{
1}{8}{9}
To erase “Check tel line 2”, press {MENU}. i
{#}{
{#}{
1}{9}{0}
When a power failure occurs, the message is displayed again.
Erase again as above.
Erase again as above.
Couldn’t connect
Confirm headset
is on then retry
L
The headset has lost connection with the base unit. Confirm
that your headset is turned on.
that your headset is turned on.
L
The headset is too far from the base unit. Move closer to the
base unit.
base unit.
Error!!
L
The handset’s registration has failed. Move the base unit and
handset away from all electrical appliances and try again.
handset away from all electrical appliances and try again.
L
Recording was too short. Try again.
Failed
L
Phonebook copy failed (page 24). Confirm the other unit (the
receiver) is in standby mode and try again.
receiver) is in standby mode and try again.
Incomplete
L
Phonebook copy is incomplete. The receiver’s phonebook
memory is full. Erase the unnecessary phonebook entries
(page 24) from the other unit (the receiver) and try again.
memory is full. Erase the unnecessary phonebook entries
(page 24) from the other unit (the receiver) and try again.
Memory full
L
The phonebook memory is full. Erase unnecessary entries
(page 24).
(page 24).
L
Messages full
L
No link to base.
Reconnect AC adaptor.
L
The handset has lost communication with the base unit. Move
closer to the base unit and try again.
closer to the base unit and try again.
L
Unplug the base unit’s AC adaptor to reset the unit. Reconnect
the adaptor and try again.
the adaptor and try again.
L
The handset’s registration may have been canceled. Re-
register the handset (page 33).
register the handset (page 33).
TG938x(e).book Page 52 Friday, July 3, 2009 10:10 AM