Panasonic KX-TVS50 ユーザーズマニュアル
4.2
CONNECTING THE KX-TVS50/80 WITH THE PANASONIC KX-TA624
70
INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX
Screen output:
This message is shown when the digital (APT) connection between the VPS and
telephone system cannot be established.
telephone system cannot be established.
Possible causes of the message: "APT Interface Connection is not Established"
11.
Start up completed.
a)
The Power Indicator light stops blinking when the start-up has been successful. (The
delay varies according to the system's condition.)
delay varies according to the system's condition.)
b)
"**ON LINE MODE**" is displayed.
c)
System prompt [>] is displayed on the screen. To enter system administration, Press
ENTER. All parameters can be set through the menu-driven program.
ENTER. All parameters can be set through the menu-driven program.
12.
Go to the System Administration Top Menu. Type [5] and Press ENTER, or Type [3] then
QSET and Press ENTER for Quick Setup and follow the Auto Configuration Instructions.
Table 15
Cause
Action
The PBX is not a KX-TA624 system.
Since the default PBX type for the
KX-TVS50/80 is to KX-TA624 at the
factory, this message will always
appear when connecting to another
type of PBX.
Since the default PBX type for the
KX-TVS50/80 is to KX-TA624 at the
factory, this message will always
appear when connecting to another
type of PBX.
Change the PBX type by using
Quick Setup (see Section 5).
Quick Setup (see Section 5).
The cabling between the PBX
extension ports and the VPS is not 4-
wire or is improperly connected.
extension ports and the VPS is not 4-
wire or is improperly connected.
The PBX is a KX-TA624 but does not
have the proper level of software
required to support APT Integration.
have the proper level of software
required to support APT Integration.
Contact National Parts Center
at 1-800-833-9626
or use Inband Integration under
hardware settings.
at 1-800-833-9626
or use Inband Integration under
hardware settings.
The PBX is not programmed properly
to support APT Integration.
to support APT Integration.
Do required integration
programming as described in
this chapter.
programming as described in
this chapter.
Active COs: 1 2
APT Interface Connection is not Established
** OFF LINE MODE **
APT Interface Connection is not Established
** OFF LINE MODE **