Nuvo NV-USBW ユーザーズマニュアル

4

(1) Make certain that the Wireless G router is powered up and operating correctly. You can test 

this by accessing the  wireless connection with a wireless-equipped PC in the area.  If the 
router is connected to an active Internet access modem (cable or DSL), then once the wireless 
icon in the lower right of the task bar shows a wireless connection, it is a good idea to simply 
open a browser and verify access to the Internet.

(2) Make certain that the NV-USBW/SX-2000WG is set up close to the NV-M3 as described in 

paragraph (1) of the previous section.  Connect the power supply to the NV-USBW/SX-
2000WG.  Connect the power cable to the power supply, and then plug it in to a live AC 
receptacle.  Observe the rectangular LED's on the side of the unit opposite the antenna.  All 
three LED's should flash on at first, then the bottom LED, labeled “Link” should flash for a few 
seconds.  Finally the Link LED should go out, and the top “Wireless” LED should begin to 
flash.

(3) Insert the NuVo NV-USBW/SX-2000WG setup disk into the wireless-connected PC operating 

on the wireless network. A top-level “Device Server Setup CD” menu screen will come up.  
Left-click on the “Device Server Setup” button on the left.

(4) The Setup Screen shown in Figure 2 will come up.  Left-click on the large “Wireless” button on 

the right.