Uniden D1789-11 ユーザーズマニュアル

The D1789 doesn’t 

ring when my 

cellular phone does.

 x Making sure your cellular phone has Bluetooth turned on.
 x Making sure your cellular phone is in range of the base.
 x Making sure the station’s ringer is not turned off. (The base doesn’t 

ring on cellular calls.)

The D1789 paired 

with my phone, but 

I can’t hear anything 

through the station.

 x Adjusting the volume.
 x Setting your cellular phone to transfer the audio to a Bluetooth 

device. Check your phone’s manual for instructions on Bluetooth 

setup and options.

 x Erase the Bluetooth pairing and repair the cellular phone to the 

base. To erase the Bluetooth pairing, see page 14.

A telephone line filter or DSL filter prevents services that use the phone line from causing

interference on your phone. To get a line filter, contact your service provider or look in an

electronics store. Plug the filter into the telephone wall jack and plug the base into the filter.

Make a test call to make sure the noise is gone.

If the liquid is only on the exterior housing of the base or handset, wipe it off and use as normal.

If you can hear liquid inside the housing:
1.  Remove all compartment covers, and disconnect all cables and cords.
2.  If liquid is leaking from any vent or hole, turn the phone so that the vent faces down. If not,

place the largest vent face down.

3.  Let dry for at least 3 days. Check for liquid inside the phone before replacing compartment

covers & reconnecting cords.

If you have problems with the base, unplug it to reset it. Plug it back in after at least a minute.
If you have problems with a cordless handset or want to replace one, reset it:
1.  Press & hold

and

at the same time until you see the

menu.

2.  If you still have the base the handset is registered to, select

, then select the

handset you want to reset. If you don’t have that base anymore, select

.

3.  To confirm, select

. The handset displays

.

If

displays on a handset, register the handset to a base before using it.

1.  On the base, open the menu and select

.

2.  On the handset, press and hold

until the handset displays

.

3.  Wait until the display says

(about 30 seconds), then pick up the

handset; press

.

#