Uniden DSS7955+2 ユーザーズマニュアル

54

The ring time setting allows you to set the number of rings the caller hears before your answering machine plays the 

outgoing message. You can set the ring time to answer after six,nine, or twelve rings. If you enable the Toll Saver 

(TS setting), the answering machine picks up after two rings if you have new messages, and after four rings if there 

are none. This way, if you make a long distance call to check your messages, you can hang up after the third ring to 

avoid long distance billing charges.

Press the 

MENU soft key. Select the ANSW. SETUP menu, and then the RING TIME submenu.

Move the cursor to select a Ring Time (6 TIMES, 9 TIMES , 2 TIMES or TOLL SAVER).
Press the 

OK soft key. You will hear a confirmation tone. 

You can choose how long callers have to record a message. Set the record time to  MINUTE or 4 MINUTES to limit 

the record time for incoming messages. If you set the record time to ANNOUNCE ONLY, the answering machine 

answers the call but prevents callers from leaving a message. 

Press the 

MENU soft key. Select the ANSW. SETUP menu, and then the RECORD TIME submenu.

Move the cursor to select Record Time ( MINUTE, 4 MINUTES, or ANNOUNCE ONLY).
Press the 

OK soft key. You will hear a confirmation tone. 

While your answering machine is set to ANNOUNCE ONLY, the base screen will display ANNOUNCE ONLY. If you 

are using the prerecorded greeting, the answering machine automatically switches to the following message: "Hello, 

no one is available to take your call. Please call again." If you are using a personal greeting, the answering machine 

continues to use that greeting.

)
2)
3)

)
2)
3)