AT&T DS1/DMi/ISDN-PRI ユーザーズマニュアル

ページ / 396
7-124
ADMINISTRATION OPTIONS AND REQUIREMENTS — GENERIC 1
Port
This field associates each trunk group member to a particular network (1 or 2),
carrier (A-E), slot (01-20), and circuit (01 -24). To keep things simple, try to match
trunk group member and DS1 channel assignments (for example, trunk group
member 1 on channel 1
Name
Night
Typically, this entry is a 7-digit telephone number. However, another candidate
would be the 10-digit trunk circuit identification number, which is available from
the circuit provider.
This is a new capability with Generic 1 and System 75, R1V3. It permits an
individual trunk member to override the 
night service 
option that is
administered on page 1 of the 
TRUNK GROUP 
screen. Allowable entries are an
extension, the attendant, or to leave blank if the  Trunk Type  field does not begin
with  auto/...
Mode
For DS1 tie trunk applications, the default and only permitted entry is 
e&m.
Type
For DS1/DMI applications, the default is 
T1 stan 
(T1 standard). Normally, this
field is not administered. The default value is appropriate.
Ans Delay
Allowable entries (in milliseconds) range from 20 to 5100 in intervals of 20. This
should only be translated if delay-dial were optioned.
Processor Interface Data Module — ISDN-PRI Applications
Each ISDN-PRI circuit pack maintains the 24th channel as the D-signaling channel. For the switch
processor to communicate with the D-signaling channel an administration link must be established
between the processor and the D-channel. The procedure for establishing this link involves
administering the following three screens:
PROCESSOR INTERFACE DATA MODULE
PROCESSOR CHANNEL ASSIGNMENTS
INTERFACE LINKS
Figure 7-66,  Data Module Screen,  depicts this procedure.