AT&T 945 ユーザーズマニュアル
Wall Installation
For best results, follow the directions in “Battery Installation” on page 9
before installing the phone.
before installing the phone.
1
If the wedge is still attached to the underside of the base
unit, follow Step 1 in “Battery Installation” on page 9 to remove
the wedge.
unit, follow Step 1 in “Battery Installation” on page 9 to remove
the wedge.
2
Reverse the handset tab.
Hold down the switchhook, then pull out the handset tab and
rotate it 180 degrees. Push the handset tab down into the
grooves so it settles into position.
Hold down the switchhook, then pull out the handset tab and
rotate it 180 degrees. Push the handset tab down into the
grooves so it settles into position.
3
Connect the telephone line cords to the telephone.
Please refer to the line cord connection instructions in Step 1
of “Table/Desk Installation” on page 11.
Please refer to the line cord connection instructions in Step 1
of “Table/Desk Installation” on page 11.
4
Connect the handset cord.
Plug one end of the coiled handset cord into the jack on the left side
of the phone. Plug the other end into the handset and hang up.
Plug one end of the coiled handset cord into the jack on the left side
of the phone. Plug the other end into the handset and hang up.
5
Connect the power adapter to the telephone.
Use only the power adapter provided with this product.
To obtain a replacement, call
1 800 222–3111
.
Plug one end of the power adapter into the jack labeled POWER
on the back of the phone. Plug the power adapter into a standard
electrical outlet not controlled by a wall switch.
on the back of the phone. Plug the power adapter into a standard
electrical outlet not controlled by a wall switch.
continued on page 14
13
INST
ALLA
TION
INST
ALLA
TION
Switchhook
Handset tab
Standard
Electrical
Outlet
Power adapter
POWER jack