AT&T 3.0 ユーザーズマニュアル

Programming the System

■ 

Form 3a, Incoming Trunks: Remote Access

■ 

Form 3b, Incoming Trunks: DS1 Connectivity (100D Module)

■ 

Form 3d, Incoming Trunks: DID

The following forms indicate the data equipment you will need to set up data

stations.

■ 

Data Form 1a, Modem Data Station

■ 

Data Form 1b, 75006 Data Station

■ 

Data Form 2, Data Hunt Groups

If you have a system programming disk created with SPM or a Translation

memory card, you do not need to program the system. Instead, you can use
the disk or memory card to restore the system; see Chapter 7, “Initializing and
Testing the System,” for instructions. If you did not receive a disk or a memory
card and it is your responsibility to program the system, see System
Programming for instructions.

If you are upgrading to Release 3.0 from Release 2.1, 2.0, 1.0, 1.1, or from the
MERLIN

® 

System,” then Chapter 7, “Initializing and Testing the System,” for upgrade
instructions.

You cannot retain the programming from the MERLIN II Communications
System. You must first upgrade the hardware, then reprogram the system.

1-4  Introduction