AT&T 518-600-016 ユーザーズマニュアル
CHANGING
ATTENDANT
POSITIONS
If you change a standard voice terminal station port
to an
attendant position or vice versa, you have reassign lines
and features to it, since all settings return to the default
and features to it, since all settings return to the default
condition. Depending upon the equipment plugged into
the port and the port’s new use, you may have to change
the voice terminal or console and any attached accessory
equipment.
the port and the port’s new use, you may have to change
the voice terminal or console and any attached accessory
equipment.
NOTE:
Be sure to record the change on the appropriate
planning forms.
The station connected to jack 01 (default intercom number
10) is an attendant position, and this cannot be changed.
You can designate up to seven other analog attendant
positions, two per analog station module.
Keep in mind that there cannot be more than eight
attendant positions. If you want to designate a new
attendant position and the system ahead y has the
maximum number, you must change an existing attendant
position to a nonattendant voice terminal before you
designate a new attendant position.
position to a nonattendant voice terminal before you
designate a new attendant position.
With a Display Console
1
2
3
4
Enter administration mode by sliding the T/P switch to
P.
P.
Press Conference twice.
The administration menu appears.
Press
[System], [Attendants]
.
Press [Position] .
A steady flashing green light appears next to each button for
each station that either is or can be an attendant position. No light
means the station cannot be an attendant position.
each station that either is or can be an attendant position. No light
means the station cannot be an attendant position.
3-68
Administering a Changed System