Mitsubishi Electronics mitsubishi ユーザーズマニュアル

Immediately after the TV is connected to an AC power source:

Pressing the front panel “INPUT” and “MENU” buttons at the same time, and holding for 5 seconds,
activates the Error Code Mode.  The ” Power LED” flashes denoting a two digit Error Code, or indicating no problem
has occured since the last Initalization.

Note:  The front panel buttons must used, NOT those on the Remote Control.

•

The number of flashes indicates the value of the MSD (tens digit) of the Error Code.

•

The flashing then pauses for approximately 1/2 second.

•

The LED then flashes indicating the value of the LSD (ones digit) of the Error Code.

•

The Error Code is repeated a total of 5 times.

Example:  If the Error Code is “34”, the LED will flash 3  times, pause, and then flash 4 times.

The Error Code designations indicating a malfunction, or no malfunction, are listed below:

Most of the adjustments can only be performed using the remote hand unit.

1. Select the signal source.
2. Press the "MENU" button on a remote hand unit.
3. Press the number buttons "5", "7", "5", "7" in sequence.  The screen will change to the Adjustment Mode.

Note: Repeat steps 1 and 2 if the circuit

adjustment mode does not appear
on screen.

12

No Error detected, check Power Supply

32

Lamp Cover is open

33

Air Filter Cover is open

34

Lamp abnormality

36

Light Engine (DMD or LAMP Fan stopped)

37

Exhaust or Lamp Ballast Fan stopped

38

Lamp temperature high

39

DMD temperature high

41

Short is detected

44

DVI cable between FMT & Engine disconnected.