Mitsubishi Electronics WD-52725 ユーザーズマニュアル

70

71

To view a V-Chip blocked program or to watch the 

program during a scheduled lock time, you must 
enter your 4-digit passcode or change the channel 
to an unlocked program.  Once you have entered 
the passcode, the V-Chip block or Lock by Time will 
remain released until the TV is powered Off and then 

On again.

V-Chip Lock Menu: Passcode

V-Chip

Select V-Chip Lock to perform the functions listed 
below.  V-Chip allows you to Block or Allow programs 
based upon rating signals sent by the broadcaster.  

The TV comes from the factory with the V-Chip Lock 

in the Off setting.  

You can turn the V-Chip on within the V-Chip Menu or 

you can use the V-CHIP button on the remote control 
to conveniently turn the V-CHIP on or off.  

The factory preset is TV-PG for TV ratings or PG for 

movie ratings, allowing only programs rated TV-PG/
PG or lower.  You can change the blocking level to 

various TV ratings and lettered categories or movie 

ratings.  After changing channels or devices, there 
may be up to a 5 second delay before the V-Chip lock 
takes effect.

Entry

You will see the screen shown in Figure 21 when you 

press V-CHIP on the remote control, the first time 
you select the V-Chip Lock menu, or after you have 
canceled your passcode.  To use the Lock, input a 
four-digit passcode with the number buttons on the 
remote control, then press ENTER.  You can delete 
a number and move back one space by pressing 

CANCEL.  You can exit without inputting a passcode 

by pressing MENU or HOME.

After setting a passcode, the V-Chip Lock is active.  

The next time you select V-Chip Lock you will see 

“...enter your passcode” instead of “...enter a new 

passcode”.  

������ ������ ����

�� �� �� ��� ����� ����� � ��� ���������

� � � �

��� ��� ������ ������� ��� ����� ������

V-Chip Start Time and V-Chip Stop 

Time

Select the times you would like the V-Chip to be active.  
By setting the V-Chip Start Time and V-Chip Stop 

Time to the same time, the V-Chip will be active 24 

hours a day.

Press ADJUST   or    to slowly select the time, 
starting with the hours.  Press and hold ADJUST   
or   to quickly select the hours, press ADJUST   to 
select the minutes.

If you forget your four-digit Passcode, 
see Appendix A.

������� �� �������

������ ������ ��� ������� ������� ��� ������ ��

����� ����

�� ����� ��� �������� ����� ���� ���������

� � � �

��� ��� ������ ������� ��� ����� ������