Jet Tools JMD-15 ユーザーズマニュアル
6
Contents of the Shipping Container
1.
Mill/Drill Machine
Accessory Package:
1.
1/2” Drill Chuck w/ Chuck Key
1.
Adjustable Carbide Facemill
1.
Facemill Arbor
2.
Bolts, Nuts, and Washers to
Attach Vise to Table
Attach Vise to Table
1.
2-1/2” Angle Vise (JMD-15)
1.
3-1/2” Angle Vise (JMD-18/18PFN)
3.
Handle Rods
3.
Rubber Knobs
1.
3/8”x1” Hex Socket Cap Screw
1.
3/8” Washer
1.
Crank Body
1.
Crank Handle
1.
3mm Hex Wrench
1.
5mm Hex Wrench
1.
23mm Hex Socket Wrench (JMD-
18/18PFN)
18/18PFN)
3.
Hand Wheels w/ Handles
1.
Can Touch-Up Paint
1.
Owner’s Manual
1.
Warranty Card
1.
Lifting Hook
Unpacking and Clean-up
1.
Finish removing the crate from the mill/drill.
Unbolt the machine from the crate bottom.
Report shipping damage, if any, to your
distributor.
Unbolt the machine from the crate bottom.
Report shipping damage, if any, to your
distributor.
2.
Clean all rust protected surfaces using a
mild commercial solvent, kerosene or diesel
fuel. Do not use paint thinner, gasoline, or
lacquer thinner. These will damage painted
surfaces. Cover all cleaned surfaces with a
light film of Mobil DTE
mild commercial solvent, kerosene or diesel
fuel. Do not use paint thinner, gasoline, or
lacquer thinner. These will damage painted
surfaces. Cover all cleaned surfaces with a
light film of Mobil DTE
Oil Heavy Medium.
Tools Needed for Assembly
8” Adjustable Wrench or 1/4” to 1-1/4”
Combination Wrench Set
Combination Wrench Set
(JMD-18 shown with optional CS-18 stand)