Pentair PS6 ユーザーズマニュアル

Page 22

To remove all labeling, programming, assignments 
and temperature settings, highlight MENU and 
press SELECT. Highlight SYSTEM SETUP 
and press SELECT (see Figure 30). Highlight 
CLEAR MEMORY and press SELECT. Highlight 
CONTINUE and press SELECT. Use the UP or 
DOWN button to highlight YES or NO and press 
SELECT. There will be about a 15 second delay 
before you see the FINISHED screen. Highlight 
CONTINUE and press SELECT to return to the 
SYS TEM  SETUP. 

In service mode, equipment protection safety 
interlocks are overridden.

MAIN MENU

HELP

PROGRAM

SET  TEMP

SET  TIME
PDA OPTIONS

SYSTEM   SETUP

SYSTEM SETUP

SOLAR PRIORITY
PUMP LOCKOUT
ASSIGN JVAs
COLOR LIGHTS
SPA SWITCH
SERVICE INFO
CLEAR MEMORY
HEAT PUMP

MORE

CLEAR MEMORY

WARNING

Clearing memory

erases ALL

stored settings.

CONTINUE

CLEAR MEMORY

FINAL WARNING

Are you SURE

that you want to 

ERASE ALL

SETTINGS

??

YES

NO

CLEAR MEMORY

FINISHED

Press SELECT

to continue.

CONTINUE

CLEAR MEMORY

ERASING

ALL

SETTINGS

please wait

Default Temperature (Pool/Spa Combination)
Default Pool Temp = 80° F
Default Spa Temp = 102° F

Default Temperature (Pool/Spa Only)
Default TEMP1 = 80° F
Default TEMP2 = 60° F

Default Spa Side Switch Settings
Button 1 = Spa (Filter Pump for pool/spa only models)
Button 2 = Spa Heater (Temp1 pool/spa only models)
Button 3 = AUX1
Button 4 = AUX2

Default Freeze Protection Settings
Filter Pump: Freeze Protection ON. 
All Other Equipment: Freeze Protection OFF
Default Activation Temperature: 38° F

NOTE  If you select SPA to be freeze protected, water 

circulation will switch between pool and spa 
every 30 minutes during freezing conditions 
once freeze mode is active.

1.  The PDA Handheld Remote has complete 

control of all functions. 

2.  All programmed settings will operate. 

3.  All safety delays and equipment protection 

in ter locks  are  operational.

1.  The power center has complete control of 

all functions. 

2.  Service mode must be turned on/off at the 

power center. 

3.  No programmed settings will work.

1.  The power center has complete control for 

three (3) hours.  

2.  After three (3) hours the system will return 

to AUTO mode. 

3.  Programmed on/off times will be 

overridden during the three (3) hours.

4.  After the three (3) hour "time out", the 

system will resume any programmed items 
that were overridden.