Patton electronic 1195 ユーザーズマニュアル
Adding/Removing a System
50
Model 1195 Getting Started Guide
6 • GUI configuration
Figure 11. Add/Remove System
2. Click New
. Enter information for all of the fields.
3. Click Add. The system will be added. The GUI supports up to 2,000 systems.
Note
When you are entering the information for the new system, assign
the correct IP address of that system. If needed, you can change the
IP address of the system. To change the IP address of the system,
make a local connection (through the COM port), then click on Set-
tings > IP Settings.
the correct IP address of that system. If needed, you can change the
IP address of the system. To change the IP address of the system,
make a local connection (through the COM port), then click on Set-
tings > IP Settings.
Removing a system
There are two ways to remove a system.
Option 1: In the Add/Remove System window, select the system, then select Remove in the Status field. The
entry of the system will be removed temporarily. The entry may be revived later.
entry of the system will be removed temporarily. The entry may be revived later.
Option 2: Click Remove
. The entry will be removed permanently. To add the same system again, you
will need to create a new entry.
Editing a system
To make necessary changes for the current entry, enter the desired changes into the fields in the Add/Remove
System window. Then, click Edit. The current entry will be updated.
System window. Then, click Edit. The current entry will be updated.