Omron C200HW-ZW3AT2-E-V2 ユーザーズマニュアル
5-14
Section
I: System Setup
137
5-14-3 Setting PC Communications — C: PC Interface
“C: PC interface” is used to set the PC to be connected, the communications
method, and the communication conditions to be used when the Controller Link
Support Software connects to the PC.
method, and the communication conditions to be used when the Controller Link
Support Software connects to the PC.
Normally, the Controller Link Support Software uses the settings only when it
connects to the PC. However, it also refers to the settings of the destination PC
Menu when Maintenance functions are used. Therefore, set the PC interface
correctly before transferring data between the Controller Link Support Software
and a node or before using Maintenance functions.
connects to the PC. However, it also refers to the settings of the destination PC
Menu when Maintenance functions are used. Therefore, set the PC interface
correctly before transferring data between the Controller Link Support Software
and a node or before using Maintenance functions.
Note For settings on the PC, see 3-3-2 PC Settings (page 25).