Omron C200HW-ZW3AT2-E-V2 ユーザーズマニュアル

This section describes how to use modems to connect the Controller Link Support Software to a remote PC via
telephone lines.

This section describes restrictions on communication methods, modem conditions, system configurations, and
setup procedures.

Online connection via modems is possible only when the following PCs and communications methods are used.

The following are the PCs and communications methods that can be used for online connection via modems.

•

Connection to the built-in Host Link port on a C200HX/HG/HE(-ZE), CV-series, CS1-series, or CQM1H PC.

•

Connection to the peripheral port on a C200HX/HG/HE(-ZE) or CS1-series PC.

•

Connection to a Host Link Unit (CV500-LK201) installed in a CVM1 or CV-series PC.

•

Connection in Host Link mode to a Serial Communications Board (CS1W-SCB21/41) or Serial Communications
Unit (CS1W-SCU21) installed in a CS1-series PC.

The modems in which the following items can be specified are required to allow online connection.

Baud rate

2,400, 4,800, 9,600, or 19,200 bps

Data bit length

7 bits

Parity

Even

Stop bits

1 bit

Data error correction and data
compression

Data error correction enabled and data
compression disabled.

MNP class 4, or V.42, etc.

Flow control

Disabled (CS/RS control disabled and Xon/Xoff
control disabled)

Automatic reception

Enabled (at PC)

ER signal

Always ON

Fixed terminal line speed mode

Disabled

Abort timer

Set to 10 minutes (example value)

Online connection via modems allows the Controller Link Support Software to connect to PCs on the Controller
Link Network as shown below.