Mitsubishi Electronics IB-1500193(ENG)-D ユーザーズマニュアル

Appendix 2 - 2

This section explains how to assemble the wire to CM10 plug connector.

Cut the cable to the following dimensions:

(Note)

Not to change cable length.

     Cable length after cutting = 35±0.5mm for CM10-SPxxS-x(D6) + Cable length

= 35±0.5mm + Cable length

Insert the clamp nut, the cable clamp, the bushing and the back shell to the cable.

(Note)

Pay attention to the direction each part is inserted.

Make sure that every part is inserted.

Strip the cable’s sheath to the A length, cut the wire set at its root and strip the core wire to the B length.

(Note)

Make sure to strip the cable to the correct length.

Do not leave cutting or scratch to the cable core.

*

When making CM10-SP10S-x(D6), strip the cable for No. 10 terminal in a way that the A length 

becomes 1mm longer than that of other cables. 

(This is to prevent excessive tension of the cable when inserting the contact to the housing in 

the next process.)

CM10-SP10S-x(D6)

18.5 to 19.5

4.5 to 5.0

CM10-SP2S-x(D6)

17.5 to 18.5

Cable length

 

Cable

Cable clamp

Bushing

Back shell

Clamp nut

A

B

Sheath

Core wire

(A+1mm for No. 10 terminal only)

Cable core